Products Produzione Molle, Bergamo, Lombardia, Italy Any sector, a continue challenge.

Traction springs

Produzione Traction springs, Bergamo, Lombardia, Italy

Technical description
We plan and produce traction springs in round wire (ø starting from 0,10 mm).
We use raw material according to UNI EN 10270-1, UNI EN 10270-2 and UNI EN 10270-3, but also special raw materials and high performances alloys. We produce springs that comply with UNI EN 13906-1, with several kinds of hooks and with the client's specifications and drawings, in different lay outs and with the required surface treatments.


  • Before undertaking the design calculations of a spring, we must consider the requirements to be achieved, in particular by defining the preload, which is the force that must be applied to the spring in order to overcome the force that keeps the coils tightened.
    The calculation of the cold coiled springs under dynamic loading is difficult, because of the complicated shape of these springs. When the springs are extended, there is a non-uniform distribution of torsional stress due to the curvature of the active coils, as in the case of compression springs. The maximum torsional stress must be calculated using the correction factor of the stress k.
  • MATERIALS
    Types of materials used for the production of the springs:
    UNI EN 10270-1: SM, SH, DM, DH (phosphate, patented, galvanized, zin
    c aluminate, with particular strengths) UNI EN 10270-2: FDC, FDCrV, FDSiCr, TDC, TDCrV, TDSiCr, VDC, VDCrV, VDSiCr
    UNI EN 10270-3: 1.4310 NS, HS 1.4310, 1.4401, 1.4568, with particular strengths
    UNI EN 12166: copper, beryllium copper, phosphor bronze
    UNI EN 10088-3: 1.4021, 1.4462, 1.4539, 1.4016, 1.4597
    Special materials and alloys, also supplied by the customers.
Specific definition:

The tension spring is usually made of wire of circular cross section, wound in a helix around an axis, with coils in contact or not, which reacts to an axial force which tends to extend the length of the spring, with or without initial tension. This spring, ideally considered as a rigid body, generally is subject to tensile load acting along its axis.

Main fields of application:
This spring must by its nature be functional within a more complex and articulated mechanism which represents the driving force. This spring is used for a large number of products, in particular the areas most affected are:
–    Electronics and electromechanics;
–    Furniture;
–    Automotive;
–    Home appliances;
–    Toys;
–    Medical;
–    Textiles;
–    Etc.



Download Traction springsDownload Hooks lay out drwgs

To obtain further info please click here
and you will get them asap.

Technology

There is no limit to our production range which includes every kind of spring with an extensive possibility of shapes and technical suitable solutions and stampings and bent components

> continue reading

Co-design

Co-Design, produzione Traction springs, Italy The success of our company is based on a very important principle: the best results are obtained not alone but through a good cooperation with the customer…

> more about

Further info

To obtain further info please click here
and you will get them asap.

Further info

Copyright © 2011 Mollificio Bergamasco. All rights reserved. | Dati Fiscali | Credits
Work with us | Contacts | Privacy
This site collects anonymous statistical data on navigation through cookies installed by authorized third parties, respecting privacy of your personal data and in accordance with standards established by law . By continuing to browse this site , clicking on links in it or simply scroll down the page, you agree to the service and the same cookie.   Cookie Policy
Ok